Sanitary equipment is a matter of improving the house, as she often without choice. It 'important to take care of the health of your property in order to avoid crisis situations and to ensure that get the most out of your hydraulic system.
When it comes to faucets, it can often replace more complicated than we realize at first too. Replacement windows can be either as part of the installation of a new application tub / sink or because your old taps are consumed. Youhowever, just wants to simply replace your taps on a foundation cosmetics.
It 'important that it should sink, like many "holes" to understand when it comes to change the taps. The amount of holes will determine whether you have two separate faucets can be installed or if you have only a portion of your needs both hot and cold water. If there is a hole with the One and TAP is limited to a mono-block mixer, if they should replace your taps. A hole, you have twoDiameter pipe coming out of the hole, one by one for hot and cold. However, there are two holes that you will be able to hold two separate taps on the sink, allowing you to use for hot water and one for cold water.
Ok now you have some basic knowledge about, for the tube in his work, you can find what they spend to eliminate the old valves. The first thing you need to ensure that you are interrupting the supply of water, and then turn off the taps are fully exposed to any type of sewage system of the left. The wayThey cut the water supply depends on the type of water that have to do. When connected to AC power, you must disable the internal check valve stop. If your faucets hot and cold feed pipes from a tank, you should turn off a gate valve / Mini-disposal Hahn. The valve can be found next to the reservoir of cold water.
You should then with one key (key) crowsfoot or touch an instrument for the mother, the supply lines connecting to cancel the taps to do. It will probablyThe water pipes at this point, so make sure you have a towel ready, then loosen the nut that hold the water taps in the village and have to remove from the dock. You will need to adapt to the surface to replace the old sealant and valves clean.
Before you start your taps again, you must compare the pipe connections on the old to the new valve fittings. If there are more then you will need an adapter to make them suitable stem.
When it comes toactual assembly of your new fixtures, you must check whether the end of the new fittings in plastic. If no connection is needed to prevent damage. One end of the connector is inserted on the tail and the other connects to existing lines. For the faucets, you should see the position of the mounting hole in the bowl touch ensuring adequate, that the disks in place between the faucet and the sink and when the cock is, is sure to be connected to supply lines in place.
If your taps are firmlypresent and were safely on the tubes, you can turn your water supply has been reconnected. Once the water is, you should check for leaks, if necessary, may appear, usually by a tightening of the links are resolved.